Flow heater switchable - Instantaneous water heater 24kW AEG DDLEÖKTD18/21/24

Flow heater switchable - Instantaneous water heater 24kW AEG DDLEÖKTD18/21/24 – EHT AEG – 222398 – 4041056022826: Switchable instantaneous water heater AEG DDLEÖKTD18/21/24 energy efficiency class A, energy efficiency class spectrum A to G, material of the pressure vessel plastic, nominal capacity 0.4l, max. permissible operating pressure 10bar, nominal power 24kW, nominal voltage 1 380V, nominal voltage 2 415V, manual operation, digital temperature display , With display, mounting type above/under the table, electronic output control, connected load 18 ... 24kW, bare wire heating system, safety shut-off pressure shut-off, degree of protection (IP) IP25, connection for cold drinking water external thread, nominal inside diameter for cold drinking water 1/2 inch (15), pipe outside diameter for cold drinking water 21.5mm, connection hot water external thread, nominal inside diameter hot water connection 1/2 inch (15), pipe outside diameter hot drinking water 21.5mm, suitable for plastic pipe, suitable for preheated water, type of control electronically, height 485mm, width 226mm, depth 93mm, weight 3 ,8kg, instantaneous water heater, fully electronically controlled, for sale Supply of washbasin, kitchen sink, shower, bathtub. Precise temperature selection using a 2-color backlit, easy-to-read multifunction display. Display of temperature, flow rate, energy consumption and time. Two memory buttons for individually adjustable temperatures. Comfort function: ECO button, automatic water volume control, shower program, ECO function for energy-saving operation. Temperature radio button for one-off temperature selection for the next tapping process. Heating block made of glass fiber reinforced polyamide. 4 heating coils lying directly in the water. Measuring turbine for precise flow rate measurement. Electronic air bubble detection. Process-controlled motor valve for precise water temperature at maximum flow rate. Temperature selection from 30 °C to 60 °C. Integrated diagnostic system. Suitable for inlet temperatures up to a maximum of 60°C (e.g. solar preheated water). Connection options for long-distance and direct tapping. For connection to plastic pipe installations with DVGW test mark. Easy assembly with separate mounting plate and quick release, with assembly template, hood disassembly from the front, without screws, electrical connection from above or below. Power supply with permanent connection. Oversink installation, undersink installation possible with accessory UT 104. Connection to all commercially available closed fittings. VDE/GS mark, radio protection mark/EMC.