Ratchet ring wrench. SW=18mm - Combination spanner 18mm 11 2518

Ratchet ring wrench. SW=18mm - Combination spanner 18mm 11 2518 – Cimco – 4021103125182: Ratchet ring wrench. SW=18mm 11 2518, wrench size jaw side=18 mm, wrench size ring side=18 mm, head width jaw side=37 mm, head width ring side=33 mm, head height jaw side=9.8 mm, head height ring side=11.3 mm, length=235 mm , Low-sparking version=no, cranked=yes, suitable for tommy bar=no, with tommy bar=no, protective insulation 1000 V=no, VDE tested=no, ratchet design=yes, number of corners=12, ratchet ring and open-end wrenches for ratcheting loosening or Fast tightening of screws and nuts in one go without setting with the ring ratchet. On one side open-end wrench with 15 degree offset, on the other side a ring spanner of the same size with built-in ratchet mechanism with special advantages: ratchet with fine teeth: 72 teeth = only 5 degrees minimum swivel angle. Left and right rotation is achieved by simply turning the key and not by means of an annoying switch lever, which often shifts unintentionally. The keys build very narrow despite the ratchet. This means that the tools can be used particularly well in confined spaces. 12-point ring with flank drive, i.e. the drive no longer takes place via the corners of the screw head but on the flanks, which means that a significantly higher power transmission is achieved and the edges of screw heads and nuts are protected Drop-forged chrome-vanadium steel, specially hardened, highly polished, nickel-plated and hard-chromed. Very high torque transmission, the DIN requirements are exceeded. 18mm