Thin bed set 1-1350 W DTIF 9.0 sqm, professional - Floor warming 150W/m² 9m² 140F0827

Thin bed set 1-1350 W DTIF 9.0 sqm, professional - Floor warming 150W/m² 9m² 140F0827 – Devi – 5703466216613: Thin bed set 1-1350 W DTIF 9.0 qm, professi 140F0827 Application floor temperature control, connection voltage 230V, connected load 1350... 1350W, output 150W/m², heat conductor load 11W/m, with carrier mat, fixation of the heat conductor glued on, number of PTC thermistors 1, length the PTC thermistor 4000mm, suitable for wet rooms, area 9m², length 18000mm, width 500mm, thickness 3.5mm, with controller, with room thermostat, with floor temperature sensor, self-adhesive, thin-bed set with touch thermostat, flexible sensor protection tube DN10, sensor sleeve made of brass, plastic nails, Assembly Instructions. The self-adhesive thin-bed heating mat with a connecting cable is ready for installation and was specially developed for installation in leveling compound or flexible adhesive directly below the floor covering. Due to the low installation height of only 3.5 mm, it is ideal for the renovation and modernization of bathrooms, showers, kitchens, etc. This underfloor temperature control system is particularly suitable for retrofitting in angled and/or large rooms, since the second connection can be fed back omitted. The heating cable with additional protective braiding for use with the FI protective circuit is attached to a plastic mesh. The length of the connecting cables is 4.0 m. PTC thermistor: 1 x 4 m, 1.0 mm², voltage: 230 V, nominal limit temperature: 120°C, specific heating output: 150 W/m², linear load: 11W, insulation: PVDF / FEP, resistance tolerance : +10% / -5%, minimum installation temperature: 5°C, smallest bending radius: 6 x dA, calculation width 50 cm, delivery width: 48 cm, mat height: 3.5 mm, protection class: IPX7, approval: EN 60335-2-96 , area 9.0 m², 0.5 x 18.0 m