Wire retainer

If cables are routed through self-drilled holes, especially if they are made of metal, there is always a risk that burrs and sharp edges will damage the insulation or even the current-carrying wires of a line or cable. In addition, in the rarest of cases, the hole produced is identical to the cable diameter. This creates a gap that allows debris to either enter or allow a loose cable to rub against the edge of the hole and become damaged over time. This is where the cable sockets from the eibabo technology store come to the rescue. These are available in different diameters, are made of soft plastic and thus close self-made holes, but also the openings at the ends of installation and empty pipes. Holes corresponding to the cable diameter can be punched through the pre-embossings attached to the cable insertion sockets, with which a tight seal of the cable bushing is then guaranteed.

Catalogue content:

In this eibabo® catalogue Cable and wire entry systems > Cable plug sealing clamp you will find items from the following product groups:

Item overview:

Blanking plug
Cable entry
Cable entry gland
Cable glands
Cable inlet
Cable plug sealing clamp
Cable socket
Choke stopper
Double membrane nozzle
Gag nipple
Grommet
Insert
Nozzle
Pipe socket
Plastic cable gland
Plastic nipple
Plug-in cable gland
Plug-in seal
Plug-in socket
Pressure compensation element
Pressure equalization nozzle
Push-in pipe socket
Push-in plug
Screw-in nipple
Sealing nipple
Sealing plug
Socket
Stepped socket

from the following manufacturers:

Manufacturer overview catalogue Wire retainer:

Corning
Eaton
Hager
Hensel
Icotek
Jacob
Kaiser
Kleinhuis
Lapp
Legrand Bticino
Lütze
Murrelektronik
Murrplastik
OBO
Phoenix
RST
Schneider Electric
SES Sterling
Spelsberg
Weidm?ller
Wiska